Securitron DKC Bedienungsanleitung PDF herunterladen (Seite 10)

PN# 500-33510

Page 10 Rev. A, 06/13

When the red octagon appears on the form, the DKC Configuration form is accessible, but the

following tabs will be grayed out and unusable:

 Import/Export tab

 Real Time Clock tab

 Event Log tab

To connect the Programming Tool to the DKC controller plug one end of the USB cable into the

USB port on the computer. Plug the other end of the cable into the DKC controller. The

connection is now complete. The DKC may be powered by connecting it to a Securitron power

supply, a plug-in regulated power supply or an AC transformer.

Once connected and powered the orange octagon will

appear on the form, which means the USB port of the

DKC must be unlocked either by using the user-defined

USB Enable code or USB Enable card (if a Wiegand card

reader or Aperio

hub is being used).

Status: DKC found but unit is locked and

sign-in has not been done

If the DKC has no USB Enable code, one must be programmed to access the DKC Programming

Tool. The USB Enable code allows the user to enable (unlock) the USB port of the DKC. This

must be done before any data can be imported or exported between the DKC and the host

computer. Ensure that the slide switch on the DKC CPU board is set to the correct door

corresponding to the installed keypad or credential reader. On the DKC CPU board, press the

push button switch SW2 until a ‘5’ is shown on the display. The yellow LED on the digital keypad

will flash once per second (if connected to a DK-37 or DK-38). Within 30 seconds enter a 2 to 7

digit code then press the * key. The red LED will flash twice signifying acceptance of the USB

Enable code. The display on the CPU board will turn off. If the DKC is connected to a credential

reader, present the USB Enable card instead of entering a 2 to 7 digit code that the keypad.

Note that only one USB Enable code may exist per door in the code database.

Once the code or card is entered, proceed with the steps shown in The Status Form section.

When using a DK-37 or DK-38 keypad type in the code on the keypad, followed by the *

(default) button. If the * has been programmed as the doorbell key, then use the # key instead.

How to Sign In

The yellow octagon appears if a username and password has already been programmed into the

DKC. For information on how to program a username and password into the DKC, see the

Custom Names and Security section of this document.

Click on the picture of the yellow octagon for the sign-in

box.

If the username or password is forgotten, click the

‘Forgot Your Username and/or Password’ link to display

the Username Password and Recovery dialog box.

Status: DKC found & unlocked but sign-

in has not been done

YELLOW

ORANGE

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Securitron DKC Bedienungsanleitung Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für Zuhause Securitron DKC