Securitron DKC Bedienungsanleitung PDF herunterladen (Seite 17)

PN# 500-33510

Page 17 Rev. A, 06/13

Page Setup: Select the paper size, source, orientation (portrait or landscape) and margins, and

printer.

Print Preview: Preview what the Event Log will look like prior to printing it.

Print: Print the active document.

Exit: Close the Event Log screen. Note that selecting Exit will delete all Event Log information

currently displayed.

The Event Log

The Event Log selection has four options:

Read All Events: Uploads all events from the DKC (the entire event log) from the DKC to the

computer.

Number of Events Displayed: Provides a count of how many events are currently displayed.

Read Only New Events: Only reads in events that are new since the Event Log was last read.

Clear Displayed Events: Clears all events from the log.

DKC Programming Using the DK-37 or DK-38 Digital Keypads

Advanced programming features can be accessed through a connected DK-37 or DK-38. These

features allow a user to customize the operation of the DKC to fit the specific needs of their

installation. Please note that the keypad is shipped in ‘Wiegand mode’ from the factory. When

interfacing with the DKC, please change the keypad to ‘Character mode’ and ensure that

‘Character’ is selected in the DKC Programming Tool.

There are two programming levels available to the user. In master program mode all

programming can be done without restriction. In supervisor program mode only commands

related to user or one-time codes can be accessed.

Enter Programming Mode

Enter master or supervisor code on the keypad, then press the * key. Yellow light will flash

indicating the digital keypad is now in programming mode. Note that once in programming

mode, the yellow light will continue to flash until program mode is exited by pressing the * key

or after a 30 second timeout period.

Setting a Code

Once in programming mode, enter a single digit prefix to indicate the type of code being

entered:

1 = Master Code 5 = USB Enable Code

2 = Supervisor Code 6 = Passage Code

3 = User Code 7 = Lockout Code

4 = Hard Code 8 = One-Time Use Code

Then enter the desired code and press the * key.

The red light will flash twice to confirm a valid entry has been entered. Note that the code length

for master and supervisor codes must be 5 to 7 digits long. Code length for all other codes must

be 2 to 7 digits long.

Deleting a Non-User Code

Once in programming mode, enter the single digit prefix to indicate the type of code being

deleted (same codes as above for setting a code), then press the # key twice to complete the

deletion. The red light will flash twice to confirm deletion.

Programming Special Functions

Once in programming mode, enter the two or single digit command followed by the * key; see

table below for the commands. The red light will flash twice to confirm when the command is

completed.

1 2 ... 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Securitron DKC Bedienungsanleitung Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für Zuhause Securitron DKC