Securitron M680BDCX Bedienungsanleitung

Securitron Magnalock Corp. www.securitron.com Tel 800.624.5625 [email protected] © Copyright, 2012, all rights reserved

PN# 500-10560 Page 10 Rev. D, 07/12 4. Install Roll Pins into Strike Plate: Remove the two (2) roll pins from the hardware packet. Insert a

PN# 500-10560 Page 11 Rev. D, 07/12 Adjustments: 1. Assemble Lock to the Bracket and Adjust: Loosen the two screws securing the mounting bra

PN# 500-10560 Page 12 Rev. D, 07/12 3. Drill Frame for Anchor Screws: Using the mounting bracket as a template, drill the four remaining hol

PN# 500-10560 Page 13 Rev. D, 07/12 Final Installation: 1. Insert the top of the Magnalock chassis at the end of the mounting bracket. Sl

PN# 500-10560 Page 14 Rev. D, 07/12 Final Wiring 1. Pull wires/cables through the wire feed-through hole(s) that are drilled in the frame. A

PN# 500-10560 Page 15 Rev. D, 07/12 4. After installation and wiring have been completed, re-install the lock cover through the lock chassi

PN# 500-10560 Page 16 Rev. D, 07/12 Cleaning Methods Apply rubbing alcohol onto a clean cloth and thoroughly wipe down the Magnalock and stri

PN# 500-10560 Page 2 Rev. D, 07/12 Recommended Tools M680BDCX Specifications Mechanical Electrical Environmental (Recommended) Physical Siz

PN# 500-10560 Page 3 Rev. D, 07/12 Magnalock Preparation 1. Using a Phillips screwdriver, remove the two (2) screws securing the cover as s

PN# 500-10560 Page 4 Rev. D, 07/12 Component Label Component Name Selection Position JP1 Jumper 1: Tamper Switch Mode Select A 3-pin jumper

PN# 500-10560 Page 5 Rev. D, 07/12 SW2 DIP Switch: PIR Enable and Delay Selection ENABLE PIR Switch 5 ON 5 second delay Switch 3 OFF (

PN# 500-10560 Page 6 Rev. D, 07/12 Magnalock Installation 1. CH1 Remove three (3) screws securing lock to mounting bracket and slide the brac

PN# 500-10560 Page 7 Rev. D, 07/12 5. Metal Door Frame - Drill Mounting Holes: Note: If installing on a wood door frame, go to Step 7.

PN# 500-10560 Page 8 Rev. D, 07/12 7. Wood Door Frame – Drill Mounting Holes: Drill two (2) 3/16” diameter holes at bracket-mounting hole ma

PN# 500-10560 Page 9 Rev. D, 07/12 Bracket Spacers Strike Installation 1. Close the door and place the template between the bracket spacers.