Securitron BPSM_Series Bedienungsanleitung PDF herunterladen

Securitron Magnalock Corp. www.securitron.com ASSA ABLOY, the global leader

Tel 800.624.5625 [email protected]

in door opening solutions

Page 1 Rev. E, 02/11

SECURITRON POWER SUPPLIES

MODELS: BPSM-12-6, 9 AND 15; BPSM-24-4, 6 AND 10

OPERATION AND INSTALLATION INSTRUCTIONS

1. DESCRIPTION

These instructions cover 6 different models as shown above. The part number expresses first

the output voltage (12 or 24V DC) and second the maximum output current capacity. For

example, a model BPSM-24-6 can supply up to 6 amps at 24 volts. Securitron large power

supplies consist of a power module and CCS8M control board to which all installer connections

are made. The board accomplishes several functions. It provides terminals for line voltage

input and eight separate DC output circuits, so that a number of devices can be powered. Each

control circuit has an individual slide switch to turn it on and off and an LED to annunciate its

status. The CCS8M control board also provides the following:

 AC input and DC output LED indicators

 Emergency release terminals (fire alarm disconnect)

 AC status (form “C” contact) and DC status (form “C” contact) terminals

 Line voltage and DC fuses

 Built-in charger for sealed lead acid or gel cell batteries

 Automatic switch over to stand-by battery when AC fails

All power supplies in the BPSM series are Class 2 rated when installed following these

instructions.

The models which incorporate the suffix “H” in the part number have not been evaluated by UL.

These power supplies have only been evaluated by UL for use in the EXD-1and EXD-1F FWAX

systems.

2. SAFETY

Two hazards are present in the supply. Line voltage input presents a high voltage shock hazard

and the DC/battery output, represent a high energy (current) hazard. A shorted battery can

swiftly supply levels of current sufficient to melt wiring insulation and cause a fire. To insure

safety, note first that the cover LED (red) is on at any time that the supply is dangerous, which

is either if it is receiving line voltage or if batteries are operating. The supply enclosure must

only be opened by trained service personnel when the red LED is on. The green LED on

the CCS8M control board is on when AC line voltage is present. Other safety features

include line voltage and DC fuses and the fact that the line voltage input terminals are under a

warning guard plate.

3. OPERATING CHARACTERISTICS

3.1 LINE VOLTAGE INPUT

110-120 VAC should be input to terminals "H", "N", "G", as shown in the drawing. This is fed to

the input of the power module through factory made connections. The green LED will illuminate

when AC line voltage is present. The line voltage current drawn by the power supply module will

be approximately half the DC output. For example, for a 4 amp power supply, the line voltage

service should be able to supply at least 2 amps. Note: if the suffix “H” appears in the part

number (i.e. BPSMH-24-4), the unit requires 220 VAC input. Apart from this change, all other

characteristics are the same.

3.2 DC OUTPUT

The maximum DC output of the power supply is expressed by the final figure in the part

number. The BPSM-24-4 can supply up to 4 amps; the BPSM-12-6, up to 6 amps etc. However,

these power supplies are adjustable and the voltage level set affects the current output capacity.

When used with batteries, the power supplies must be set at 12.5% over voltage (13.5 V for

12 volt supplies and 27 V for 24 volt supplies). This is the factory setting and if the voltage is

to be changed, use the potentiometer marked "V Adj" on the power supply module. The current

rating takes into account the possibility of the supplies operating at 12.5% over voltage.

1 2 3 4 5 6

Inhaltsverzeichnis

Seite 1 - SECURITRON POWER SUPPLIES

Securitron Magnalock Corp. www.securitron.com ASSA ABLOY, the global leader Tel 800.624.5625 [email protected] in door opening solution

Seite 2 - Page 2 Rev. E, 02/11

PN# 500-19400 Page 2 Rev. E, 02/11 Therefore any supply which is operated at its nominal voltage (12 or 24 v) can supply about 20% more than it

Seite 3

PN# 500-19400 Page 3 Rev. E, 02/11 power supply has gone into automatic shut off (discussed later). Always replace any blown fuse with the same

Seite 4

PN# 500-19400 Page 4 Rev. E, 02/11 FIG. 1: POWER SUPPLY WIRING WITH CCS8M BOARD R1R2R3R4R5R6R7R8P1P2P3P4P5P6P7P8F1F2FAH DCFUSEHNG

Seite 5 - TOTAL CURRENT DRAWN

PN# 500-19400 Page 5 Rev. E, 02/11 FIG 2: CHART TO DETERMINE SIZE OF BATTERY PACK MIN 1 HR 2 HR4 HR8 HR 16 HR 24 HR 48 HR 72 HRUL STD.150 MA30

Seite 6 - 6. MAGNACARE

PN# 500-19400 Page 6 Rev. E, 02/11 6. MAGNACARE LIFETIME REPLACEMENT WARRANTY For warranty information visit www.securitron.com/en/site/secur

Kommentare zu diesen Handbüchern

Keine Kommentare

Securitron BPSM_Series Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Stromversorger Securitron BPSM_Series herunter. Securitron BPSM_Series User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Stromversorger Securitron BPSM_Series