Securitron PDB-8F8R Bedienungsanleitung PDF herunterladen

PDB-8F8R Power Distribution for Access Control with Fire Interface module

Securitron Magnalock Corporation

10027 S. 51

St., Ste. 102

Phoenix, AZ 85044

Doc.# 500-33045 Rev. A: Installation specifications subject to change without notice

ASSA ABLOY, the global leader

in door opening solutions.

Phone: (800) MAGLOCK

[email protected]

www.Securitron.com

Page 1 of 3

PDB-8F8R Power Distribution for Access Control with Fire Interface module

Controls and Distributes Power with 8 Control Relays with an EOL Fire trigger Interface

Power Interface for Access Control, CCTV, Fire, HVAC, Elevator,

and general low voltage system control

Note: Fire, HVAC and Elevator Control has not been evaluated by UL

Features:

 8 Heavy duty Relays with individual Inputs and Status LED’s

 Each Relay Input can be Activated from Low Current Open Collector,

Normally Closed or Normally Open Switch

 EOL End of Line Resistor Fire Interface Master Trigger de-energizes all

Output Relays that are Enabled

 Universal 11 – 27.5Vdc power input

 Available with Fuses or PTC Circuit Breakers

Note: Only the 500mA fuse version of the board has been evaluated by UL

Note: The outputs of the PDB-8F8Rare power limited when connected to

the AQD3 power-Limited power supply

 Each Output may be Individually Configured for:

o Fire Trigger (FT) Enabled or (FTD) Disabled

o FUSE model can provide optional Dry Contacts

o N/O or N/C Option Configures the Relay Switched Output

 Each Output 1-8 has a protected, continuous Output and a Relay controlled

Output

 TRG LED Green Indicates Trigger Status

 Control Power and Main Lock Power may be Isolated

(Separate Power Supplies) at Users Option

Note: Dual/separate power source configuration has not been evaluated by UL and

cannot be configured for UL Listed

products

 All Terminal Blocks are Pluggable by Channel & Function

 Made in the USA with a Lifetime Warranty

Description / Instructions

The PDB-8F8Ris a versatile, compact way to distribute and

control power for Access Control Systems with Fire Alarm

Interface. The PDB-8F8Ris an 8 position power

distribution board with individual Relays with input (IN)

control for each output (OUT). An EOL resistor trigger

input (TRIG), will force all output relays to de-energize that

are selected (FT). In a typical installation, the TRIG would

be connected to a Fire Alarm panel via a set of contacts.

When the Fire Alarm trips, all enabled relays would be

forced to be de-energized to unlock electric doors, shut

down air systems, and or return elevators to ground floor.

Input / Output Terminals, Jumpers and LED

Details and Specifications

Control Power (- CONTR +) Two position un-pluggable

terminal block is used to power the coils of the relays. The

control voltage must be between 11 and 27.5 Vdc. Each

relay energized will draw 20ma of current. By default,

Control Power and Main Power are connected together

with jumpers J1 & J2 so no connection would be made

here unless you were using Dual/separate power as

described below. Note Dual/separate power source

configuration has not been evaluated by UL and cannot be

configured for UL Listed products.

Main Power (- POWER +) Two position un-pluggable

terminal block provides the power to the outputs to be

distributed and power to Control through J1 & J2. In a

normal application the Power must be between 11 and

27.5 Vdc and would be connected here.

Dual/Separate Power J1 & J2 Jumpers Note

Dual/separate power source configuration has not been

evaluated by UL and cannot be configured for UL Listed

products. J1 Connects (-) Power to (-) Control, J2

Connects (+) Power to (+) Control. By default J1 & J2 are

connected together. When J1 & J2 are cut, you must

supply 11 to 27.5Vdc to Control power, then you may

connect any voltage to 32V AC or DC to the Main Power

Terminals. See Dual/Separate Power application figure

below.

Inputs (1-8 IN C) Eight, two position un-pluggable terminal

blocks. When IN & C are shorted together, the like number

output relay will energize. Each relay can also be

energized by an open collector that is common to the

1 2 3

Page 1 of 3 1
Page 2 of 3 2

Inhaltsverzeichnis

Seite 1 - Page 1 of 3

PDB-8F8R Power Distribution for Access Control with Fire Interface module Securitron Magnalock Corporation 10027 S. 51st St., Ste. 102 Phoenix,

Seite 2 - Page 2 of 3

PDB-8F8R Power Distribution for Access Control with Fire Interface module PDB-8F8R Instructions: Doc.# 500-33045 Rev. A Page 2 of 3 control pow

Seite 3

PDB-8F8R Power Distribution for Access Control with Fire Interface module PDB-8F8R Instructions: Doc.# 500-33045 Rev. A Page 3 of 3 PDB-8F8R Ty

Kommentare zu diesen Handbüchern

Keine Kommentare

Securitron PDB-8F8R Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Stromversorger Securitron PDB-8F8R herunter. Securitron PDB-8F8R User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Stromversorger Securitron PDB-8F8R